How to bleed a radiator, explained

Bleeding a radiator

Bleeding a radiator is an easy and cheap fix for combatting cold and patchy radiators. It's something anyone can do in their own home without the need for a heating or plumbing engineer.

 

Why do I need to bleed my radiators?

 

Radiators become less effective the more gas there is trapped within them. Bleeding your radiators will release the trapped air allowing the hot water to circulate freely.

Enabling you to heat your home more effectively and efficiently, bleeding your radiators regularly is an important part of maintaining your central heating system.

 

What do I need to bleed my radiators?

 

  • A radiator key – these can be found in all good DIY stores
  • A dry cloth
  • A cold central heating system

 

How do I bleed my radiators?

 

  • Before you do anything you’ll need to ensure that your central heating and hot water are switched off at the boiler. This will enable you to handle your radiators safely.
  • Locate the valve at the top or side of your radiator.
  • Position your cloth beneath the valve, ready to catch any water that’s likely to escape.
  • Insert your radiator key into the square groove of the valve and slowly turn it anti-clockwise.
  • After a few seconds you should hear a hissing noise, which is the sound of air escaping from your radiator.
  • Once the air has escaped, it will usually be followed by water. When a small amount of water starts to drip, close the valve by turning your radiator key clockwise.

 

How do I know if bleeding my radiators has worked?

 

Once you’ve closed your radiator valves, it’s safe to turn your central heating and hot water back on. If you’ve been successful your radiators should start to heat up within a few minutes.

You can also check the pressure gauge on your boiler and check that it reads between 1-1.5 bar.

 

Can I use automatic radiator valves to bleed my radiators? 

 

Depending on what type of radiators you have in your home, it may be possible to bleed them automatically using an auto vent. These handy devices are attached to your radiator valves and let out air gradually over time. Helping to keep your radiators working efficiently, with an auto vent you won’t need to bleed them manually.

Information and other materials on this website are not intended to constitute professional advice and should not be relied upon. Please see our Terms of Use for further details.

Related articles


Radiators aren't warm enough

Radiators aren’t warm enough

While your boiler and radiators might be in good working order, from time to time you may find that your heaters aren’t getting fully hot.   ...
Gas safety certificate cp12

Gas Safety Certificate (CP12) explained

A Gas Safety Certificate is a report which outlines the appliances tested in an annual gas safety check. Also known in the trade as a CP12, Gas...
Oil boilers oil powered heating system

Oil boilers

Using oil to heat hot water that is then circulated through the central heating system, under UK law, since 2007 all oil-fired boilers must have a...

Get a Boiler Quote

Need a new boiler? Get a boiler quote online in 60 seconds.

Get a boiler quote